Dignity Lifts Bidet Toilet Lift WL2 – Integrated Bidet & Dryer

Yes — the WL2 is designed to handle all of your hygiene needs. Many users find turning, leaning, and wiping difficult. The WL2’s bidet functions cleanse you thoroughly, and the integrated blow dryer keeps you dry and comfortable. It even includes a heated seat for added comfort, so every aspect of your routine is covered.

The WL2 gently lowers you to the seat and provides a slow, steady lift back to a standing position. The controlled 20-second rise gives your legs time to regain circulation and feeling before you stand — helping you avoid light-headedness and keeping you safe and stable throughout.

No. The WL2 is specifically designed to prevent that situation. Even if your legs feel stiff or numb after sitting, the lift’s steady 20-second rise gives your body time to adjust before you’re fully upright. You’ll always be able to get back on your feet safely.

Operation is simple — a single knob cycles the WL2 through a complete wash and dry cycle, leaving you clean and dry without any reaching or twisting. A multi-function remote also lets you customize water temperature, pressure, nozzle position, and dryer temperature to your preference.

The WL2 is compatible with almost all elongated toilets, fitting bowl heights from 14 inches (older, lower toilets) up to 18½ inches (taller modern toilets). It features adjustable and removable legs to accommodate virtually any toilet height. Note: the bidet is sized for elongated bowl toilets.

Yes, in two ways. Standard raised toilet seats or extra-tall toilets can sometimes contribute to discomfort during use. The WL2 positions you at a lower, more natural angle that supports better body mechanics. Additionally, some users find that the bidet’s spray function helps stimulate a more comfortable bowel movement.

Most likely yes. The WL2 has a width of 24⅞ inches, designed to fit within the standard minimum toilet nook width required by most building codes (25 inches). It’s built to work in even smaller bathrooms.

The WL2 supports users up to 300 lbs. It offers 19½ inches of hip room between the handles (comparable to a standard office chair) and provides 14 inches of lift from a seated position, measured at the rear of the seat. The 20-second lift cycle ensures a safe, steady rise for all users within the weight limit.

Installation requires basic plumbing and electrical knowledge — similar to installing a new faucet. The WL2 “Ts” into your toilet’s existing water supply line, so no new supply line is needed. It has a built-in water heater, so hot water hookup is not required. For the electrical connection, the lift needs a standard three-prong GFI outlet. The included 31-inch power cord has an inline Ground Fault Interrupt and is approved for use with an extension cord if needed. We recommend having a capable handyperson assist, as the unit weighs approximately 60 lbs. Assembly takes about 60 minutes.

The WL2 requires a nearby GFI (Ground Fault Interrupt) electrical outlet. It uses electricity to heat the bidet water, power the lifting mechanism, run the blow dryer, and maintain the heated seat. The 31-inch power cord includes an inline GFI and is compatible with an extension cord — however, we strongly recommend keeping all bathroom electrical cords elevated and away from floor pathways for safety.

• Dignity Lifts WL2 Bidet Toilet Lift
• Adjustable/removable feet
• Expanding fasteners to secure the lift to your toilet
• Plumbing tee, water supply line, and inline filter for bidet installation
• Assembly instructions (approx. 60 minutes, light plumbing knowledge required)
• Remote control for bidet functions
• Remote control for up/down lift functions